Removing and installing the cover in the front wheel housing
You must remove the cover from the front wheel housing before you can change the front bulbs.
■ To remove: switch off the lights.
■ Turn the front wheels inwards.
■ Remove securing pin 2 using a suitable tool.
■ Slide cover 1 up and remove it.
■ To install: insert cover 1 again and slide it down until it engages.
■ Insert securing pin 2.
Low-beam headlamps (halogen headlamps)
WARNING
These bulbs are pressurized.
They can explode when being changed if: • they are still hot • they hit an object when being removed • they are dropped There is a risk of injury.
You should wear eye protection and clean gloves when you are changing a bulb. If necessary, have bulbs changed at a qualified specialist workshop.
■ Remove the cover in the front wheel housing .
■ Turn housing cover 1 counter-clockwise and pull it out.
■ Turn bulb holder 2 counter-clockwise and pull it out.
■ Take the bulb out of bulb holder 2.
■ Insert the new bulb into bulb holder 2.
■ Insert bulb holder 2 into the lamp and turn it clockwise.
■ Align housing cover 1 and turn it clockwise until it engages.
■ Replace the cover in the front wheel housing .
High-beam headlamps (halogen headlamps)
WARNING
These bulbs are pressurized.
They can explode when being changed if:
• they are still hot • they hit an object when being removed • they are dropped There is a risk of injury.
You should wear eye protection and clean gloves when you are changing a bulb. If necessary, have bulbs changed at a qualified specialist workshop.
■ Switch off the lights.
■ Open the hood.
■ Turn housing cover 1 counter-clockwise and pull it out.
■ Pull lever = upwards and remove bulb holder 2.
■ Take the bulb out of bulb holder 2.
■ Insert the new bulb into bulb holder 2.
■ Simultaneously press bulb holder 2 and pull lever 3 downwards.
■ Align housing cover 1 and turn it clockwise until it engages.
Engine number
Example: G 550
1 Plate with information on emissions
testing, including the confirmation of the
emission standards at U.S. federal level
as well as for California
2 Engine number (stamped into ...
Tire pressure specifications
Important safety notes
WARNING
Underinflated or overinflated tires pose the
following risks:
• the tires may burst, especially as the load
and vehicle speed increase.
• the tires may wear excess ...
Opening and closing the sliding
sunroof
Overhead control panel
1 To raise
2 To open
3 To close/lower
► Turn the SmartKey to position 1 or
2 in the ignition.
► Press or pull the switch in the
corresponding direction.
& ...