Installing the towing eye
Example: towing eye mounting covers
1 Front cover
2 Back cover
Vehicles with a trailer tow hitch: if possible, connect the towbar to the trailer tow hitch .
The brackets for the screw-in towing eyes are located in the bumpers. They are at the front and at the rear, under the covers.
■ Remove the towing eye from the vehicle tool kit .
■ To open the cover at the front: press the mark on cover 1 inwards in the direction of the arrow.
■ To open the cover at the rear: insert a flat, blunt object into the cutout and lever cover 2 out of the bumper.
■ Take cover 1 or 2 off the opening.
■ Screw the towing eye in clockwise to the stop and tighten it.
Removing the towing eye
■ Loosen the towing eye and unscrew it.
■ Attach cover 1 or 2 to the bumper and press until it engages.
■ Place the towing eye in the vehicle tool kit.
HOLD function
Important safety notes
WARNING
When leaving the vehicle, it can still roll away
despite being braked by the HOLD function if:
• there is a malfunction in the system or in
the voltage supply.
• t ...
General notes
Before you first drive off, read this Operator's
Manual carefully and familiarize yourself with
your vehicle.
For your own safety and a longer vehicle life,
follow the instructions and warning n ...
Vehicle identification number (VIN)
1 VIN (stamped into the chassis on the
right-hand side, when viewed in the
direction of travel)
1 VIN (on the lower edge of the windshield)
The VIN can be found in the following
locations:
• ...