Activating/deactivating the residual heat function
The "residual heat" function is only available in Canada.
It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on the coolant temperature and on the interior temperature that has been set.
The blower will run at a low speed regardless of the airflow setting.
If you activate the residual heat function at high temperatures, only the ventilation will be activated.
► Turn the SmartKey to position 0 in the ignition lock or remove it.
► To activate: press the 
button.
The indicator lamp in the 
button
lights
up.
► To deactivate: press the 
button.
The indicator lamp in the 
button
goes
out.
Residual heat is deactivated
automatically:
• after approximately 30 minutes
• when the ignition is switched on
• if the battery voltage drops
• if the coolant temperature is too low
See also:
Transporting the vehicle
Only lash the vehicle down by the wheels
or wheel rims, not by parts of the vehicle
such as axle or steering components.
Otherwise, the vehicle could be damaged.
The towing eyes or trailer tow h ...
Vehicle identification number (VIN)
1 VIN (stamped into the chassis on the
right-hand side, when viewed in the
direction of travel)
1 VIN (on the lower edge of the windshield)
The VIN can be found in the following
locations:
• ...
Towing and tow-starting
Important safety notes
WARNING
If you tow the vehicle, you must use a rigid
towing bar if:
- the engine is not running.
- there is a brake system malfunction.
- there is a malfunction in the po ...