Activating/deactivating the residual heat function
The "residual heat" function is only available in Canada.
It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on the coolant temperature and on the interior temperature that has been set.
The blower will run at a low speed regardless of the airflow setting.
If you activate the residual heat function at high temperatures, only the ventilation will be activated.
► Turn the SmartKey to position 0 in the ignition lock or remove it.
► To activate: press the 
button.
The indicator lamp in the 
button
lights
up.
► To deactivate: press the 
button.
The indicator lamp in the 
button
goes
out.
Residual heat is deactivated
automatically:
• after approximately 30 minutes
• when the ignition is switched on
• if the battery voltage drops
• if the coolant temperature is too low
See also:
360° camera (surround view)
Important safety notes
The 360° camera is only an aid. It is not a
replacement for your attention to your
immediate surroundings. You are always
responsible for safe maneuvering and
parking. When ...
Steering wheel
Important safety notes
WARNING
Do not adjust the steering wheel while driving.
Adjusting the steering wheel while driving, or
driving without the steering wheel adjustment
feature locked could c ...
Determining the correct load limit
Step-by-step instructions
The following steps have been developed as
required of all manufacturers under Title 49,
Code of U.S. Federal Regulations, Part 575
pursuant to the "National Traffic ...