Vehicle tool kit
General notes
When they leave the factory, vehicles are not equipped with the tools needed to change a wheel, such as a jack or lug wrench. Some tools for changing a wheel are specific to the vehicle. To obtain tools approved for your vehicle, contact a qualified specialist workshop.
The vehicle tool kit contains:
R Vehicle tool kit bag with:
- a fuse extractor
- an Allen key, e.g. to operate the sliding
roof manually in an emergency
- a pump lever for the vehicle jack
- a screwdriver
- a lug wrench
R Jack
Vehicle tool kit
The vehicle tool kit is under the cover in the footwell in front of the rear bench seat.
► Fold cover 1 to the side.
► Pull vehicle tool kit 2 out by the tab.
Jack
Make sure that, while installing the vehicle jack, there are no cables on the holder, in order to avoid them becoming trapped.
The jack is located under the rear bench seat on the right-hand side when viewed in the direction of travel.
► Fold rear bench seat forwards.
► Open cover 1.
► Pull bar 3 upwards and detach from tab 4.
► Remove jack 2.
See also:
Hood
Important safety notes
WARNING
If the hood is unlatched, it may open up when
the vehicle is in motion and block your view.
There is a risk of an accident.
Never unlatch the hood while driving ...
Changing the rear bulbs
G 55 AMG only: protective grille
Make sure that the protective grille does
not hit any painted surfaces.
You could otherwise damage the
paintwork.
Protection grille (AMG vehicles)
You must r ...
Service interval display
Service messages
Information on the type of service and service
intervals (see the separate Maintenance
Booklet).
You can obtain further information from an
authorized Mercedes-Benz Center or a ...