Hazard warning lamps
► To switch on the hazard warning lamps:
press button 1.
All turn signals flash. If you now switch on a turn signal using the combination switch, only the turn signal lamp on the corresponding side of the vehicle will flash.
► To switch off the hazard warning lamps
: press button 1.
The hazard warning lamps automatically
switch on if:
• an air bag is deployed
• the Emergency Tensioning Devices are
triggered, or
• the vehicle is slowed down rapidly from a
speed of over 45 mph (70 km/h) and
comes to a halt
The hazard warning lamps switch on automatically if an air bag or the Emergency Tensioning Devices are triggered and the SmartKey is in position 1 in the ignition lock.
The hazard warning lamps switch off automatically if the vehicle reaches a speed of over 6mph (10km/h) again after a full brake application.
The hazard warning lamps still operate if the ignition is switched off.
See also:
Adjusting the head restraints
Important safety notes
WARNING
For safety reasons, always drive with the rear
head restraints in the upright position when
the rear seats are occupied.
Keep the area around head restraints clea ...
Switching the rear window wiper on/
off
■ Turn the SmartKey to position 1
or 2 in the ignition lock .
■ Turn switch : on the combination switch
to the corresponding position.
When the rear window wiper is switche ...
Vehicle tool kit
General notes
The vehicle tool kit can be found in the
stowage well under the cargo compartment
floor.
Apart from certain country-specific
variations, the vehicles are not equipped
with a tire-c ...