Automatic locking feature
1 To deactivate
2 To activate
■ To deactivate: press and hold button 1 for about five seconds until a tone sounds.
■ To activate: press and hold button 2 for about five seconds until a tone sounds.
If you press one of the two buttons and do not hear a tone, the relevant setting has already been selected.
The vehicle is locked automatically when the ignition is switched on and the wheels are turning.
You could therefore be locked out if:
• the vehicle is being pushed.
• the vehicle is being towed.
• the vehicle is on a roller dynamometer.
You can also switch the automatic locking function on and off using the on-board computer .
See also:
Display messages
General notes
WARNING
All categories of messages contain important information which should be taken
note of and,
where a malfunction is indicated, addressed as soon as possible at an authorized
...
Underinflated or overinflated ti
Underinflation
WARNING
Tires with pressure that is too low can
overheat and burst as a consequence. In
addition, they also suffer from excessive and/
or irregular wear, which can severely impair
...
Notes on towing a trailer
Important safety notes
WARNING
If you install a ball coupling other than the one
delivered with the vehicle, the trailer tow hitch
and the rear axle may be overloaded. This
applies especially if ...