General notes
For reasons of safety, Mercedes-Benz recommends that you drive with the lights switched on even during the daytime. In some countries, operation of the headlamps varies due to legal requirements and self-imposed obligations.
Driving abroad
Conversion to symmetrical low beam
Switch the headlamps to symmetrical low beam in countries in which traffic drives on the opposite side of the road from the country where the vehicle is registered. This prevents glare to oncoming traffic. When using symmetrical lights, the edge of the road is not lit as widely and as far ahead as normal.
Have the headlamps converted at a qualified specialist workshop as close to the border as possible before driving in these countries.
Conversion to asymmetrical low beam after returning
Have the headlamps converted back to asymmetrical low-beam headlamps at a qualified specialist workshop as soon as possible after crossing the border again.
Operating the on-board computer
Overview
1 Multifunction display
2 Switches on the Voice Control System;
see the separate operating instructions
3 Right control panel
4 Left control panel
5 Back button
■ To activate t ...
Cleaning the wheels
WARNING
Do not use power washers with circular-jet
nozzles (dirt grinders) to clean your vehicle, in
particular the tires. You could otherwise
damage the tires and cause an accident. ...
Definition of terms for tires and
loading
Tire ply composition and material used
Describes the number of layers or the number
of rubber-coated belts in the tread and the
sidewall of the tire. These are made of steel,
nylon, polyester and ...